I am going to try one of these. The spring in my ten round is so friggin tight, it barely works. Should help reduce the spring tension.
https://www.coreshooting.com/products/a ... 3110569795
AI Magazine Extender
Moderators: deerhunter338mag, stokesrj, trazman
- Corjack
- Administrator
- Posts: 10260
- Joined: Thu Jun 11, 2009 2:28 pm
- Location: Missouri
- Location: Booger county Missouri
- Contact:
- deerhunter338mag
- Global Moderator
- Posts: 9868
- Joined: Fri Jun 12, 2009 12:50 am
- Location: Australia
- Location: Melbourne Australia
Re: AI Magazine Extender
They look alright I need to make my magazine smaller. I don't use it as my rounds are a lot longer that the clip it's self, but I need it as it stop the round from dropping when loading. It's a pain as its really big and hits the ground sometimes and just digs into everything.
You do not have the required permissions to view the files attached to this post.
Measure it, when it’s on the deck
- Gun Barrel Ecologist
- Moderator
- Posts: 5052
- Joined: Sun Aug 23, 2009 12:54 pm
- Location: New Zealand
Re: AI Magazine Extender
DH338 you need one of these but I'm not sure if they make one for the Lapua
http://originalbobsled.com/BoltGunSleds.aspx
http://originalbobsled.com/BoltGunSleds.aspx
- deerhunter338mag
- Global Moderator
- Posts: 9868
- Joined: Fri Jun 12, 2009 12:50 am
- Location: Australia
- Location: Melbourne Australia
Re: AI Magazine Extender
Thanks GBE that is what I've been looking for. I'll email them to see if the make them for the 338Lap.
Measure it, when it’s on the deck