Blaserbuds will change server

Put any topics that do not fit elsewhere in this forum. A good place to just BS.

Moderators: skeetshot, deerhunter338mag

Post Reply
Explorer
Administrator
Posts: 658
Joined: Sun Jun 28, 2009 12:50 pm
Location: Denmark
Location: EU / Denmark / Randers

Blaserbuds will change server

Post by Explorer »

We have been informed from our hosting service that we will be moved to a new server this weekend, it take place between 01:00 AM and 03:00AM (ET) on Sunday, January 17, 2010.

The move to the new server should give us a much better performance 8-)

Thanks
Thanks Bjarne

User avatar
Corjack
Administrator
Posts: 10258
Joined: Thu Jun 11, 2009 2:28 pm
Location: Missouri
Location: Booger county Missouri
Contact:

Re: Blaserbuds will change server

Post by Corjack »

Thanks for that info Bjarne, you are the best Website ingeniør, BlaserBuds has ever had! :lol:
There are no fleas on the 9.3s


Booger county time and temp
Image
Click for weather forecast

Biebs
Meister der jagd
Posts: 1005
Joined: Sun Jun 28, 2009 10:02 pm
Location: Very NW Tip of NJ, where NJ, PA, and NY meet

Re: Blaserbuds will change server

Post by Biebs »

INGENIOR ??? Isn't that a dirty word or something ???????????

Explorer
Administrator
Posts: 658
Joined: Sun Jun 28, 2009 12:50 pm
Location: Denmark
Location: EU / Denmark / Randers

Re: Blaserbuds will change server

Post by Explorer »

Maybee but ingeniør is the Danish version of engineer but I don't see that much engineer at this point :roll: . Here in Jutland in DK we don’t have interest in titles, we look at the payment instead, and Corjack pay good attention to members of the board ;)
Thanks Bjarne

User avatar
Olsen
Moderator
Posts: 3271
Joined: Fri Jun 12, 2009 2:23 am
Location: Denmarkk
Location: Denmark

Re: Blaserbuds will change server

Post by Olsen »

Yes we have some real good workers over here ;)
Olsen

Blaser R8 Proff Succes .308 win - 9,3x62

2 shots in the same hole is often luck......3 in the same hole is using Olsens shooting stick....

Post Reply

Return to “Open discussion”