BD14 Case

[Cjpcombos]

So I ordered the Blaser ABS A case when I got my BD14 as it was listed in the back of the manual saying that it would fit. Well the case showed up today and that is far from true. The cocking piece rests on the flat mating surface of the case when I have it in the best possible orientation. It just does not seem to fit right in any way. Does anyone with a BD14 also have a Blaser hard case? Which model of hard case fits the best? I may chuck this on the classifieds for someone with a gun that better fits the case (maybe an F16 or a K95 fits it better?) as the shipping to the US cost a fair bit and for returns from outside Germany are at the customer's expense.

20250915_190009.jpg

[canalrifle]

From the photo, it looks like if you tilt the butt of the stock with sling swivel more towards the space with the barrel, it would just fit.

[MM]

Check out Negrini cases they probably have a case that fits. They have a US location Missouri I think and they are easy to deal with.

[Cjpcombos]

From the photo, it looks like if you tilt the butt of the stock with sling swivel more towards the space with the barrel, it would just fit.

Sadly there is not room in the wrist area for that; if I were to tilt it down like that, the cocking lever would be trying to stick out of the case entirely by the handle.

[Cjpcombos]

Check out Negrini cases they probably have a case that fits. They have a US location Missouri I think and they are easy to deal with.

It looks like the Negrini case that is very similar to the Blaser case I got has a better internal arrangement to it. I will probably go with that, thank you. I'm also a little annoyed that Blaser told me to "just squeeze it in a little bit"; I don't think that is great advice considering the high quality of their products...

[Cjpcombos]

Just got an email back from Blaser and the customer service rep talked to some other folks at Blaser and they are designing a case that will better fit the BD14. If they give me a timeline, I will share it.